Rear Hatch

Please feel free click the link at the bottom of any post and leave a comment, suggestion, or anything pertinent to the project.

The rear hatch is currently being constructed.
















Mr. Simmons, Ian, and Shane discussing the construction plan for the hatch.
















Ian, Shane, Derek, and John all hard at work.















John working on the installation of the hinge.















Derek constructing the frame.
















Derek and Ian are assembling the hatch.
















John is nailing the hatch together.

Air Conditioner

Please feel free click the link at the bottom of any post and leave a comment, suggestion, or anything pertinent to the project.















The air conditioner installed, as seen from the cabin.















Derek is working on the brackets for the air conditioner.

Roof

Please feel free click the link at the bottom of any post and leave a comment, suggestion, or anything pertinent to the project.

The roof has had some more work done to it.



























































All Wood Glue by Smith&Co. was used to glue the 1/2"x 2 1/2" oak trim pieces.















Fill It Epoxy Filler was used to fill the kerfs and screw holes.

The interior cabinets have been finished.

Electrical Work

Please feel free click the link at the bottom of any post and leave a comment, suggestion, or anything pertinent to the project.
















Today, an interior light was installed. The wiring was soldered and then secured together using thin wall heat shrink tubing from NAPA.













































Derek working on the light.






























The insulation board is being installed today as well.

Framework

Please feel free click the link at the bottom of any post and leave a comment, suggestion, or anything pertinent to the project.















John is working on the frame for the interior cabinets.















Derek is making the frame for the rear hatch.

Interior Roof Panels

Please feel free click the link at the bottom of any post and leave a comment, suggestion, or anything pertinent to the project.

In the past few days, we have been contouring the birch plywood to fit the shape of the trailer.

The plywood was sprayed with hot water and tensioned with ratchet straps. We also boiled water and layed wet towels on the surface over night.














The ceiling was shaped by forming the birch around the outside, and being adjusted as needed during installation.